chara:fringe_offsets
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
chara:fringe_offsets [2022/09/08 00:44] gail_stargazer |
chara:fringe_offsets [2022/09/08 01:34] gail_stargazer |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| A new baseline solution was created on 2022Sep07 and has been set as the default. | A new baseline solution was created on 2022Sep07 and has been set as the default. | ||
| - | S1: -0.5 mm to -0.3 mm\\ | + | S1: -0.5 mm to -0.1 mm\\ |
| - | S2: -1.2 mm to -0.9 mm\\ | + | S2: -1.2 mm to -0.7 mm\\ |
| - | E1: -1.1 mm to -1.0 mm\\ | + | E1: -1.1 mm to -0.6 mm\\ |
| - | E2: -1.1 mm to -1.0 mm\\ | + | E2: -1.1 mm to -0.5 mm\\ |
| - | W1: -0.7 mm to -0.5 mm\\ | + | W1: -0.7 mm to -0.3 mm\\ |
| W2: Reference Cart | W2: Reference Cart | ||
| Line 15: | Line 15: | ||
| initast / | initast / | ||
| - | Load previous solution using:\\ | + | Load previous solution using in ople:\\ |
| - | / | + | initast |
| A new baseline solution was created on 2022Jun18 and has been set as the default. | A new baseline solution was created on 2022Jun18 and has been set as the default. | ||
chara/fringe_offsets.txt · Last modified: 2023/08/30 16:57 by gail_stargazer
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
