This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
chara:mircx_monitors [2020/08/11 00:50] gail_stargazer |
chara:mircx_monitors [2020/08/11 20:05] gail_stargazer |
||
---|---|---|---|
Line 1: | Line 1: | ||
==== Displays for the MIRC-X wolverine2 monitors ==== | ==== Displays for the MIRC-X wolverine2 monitors ==== | ||
- | Follow these instructions to get the wolverine2 monitors in the control room to display the MIRC-X | + | Follow these instructions to get the wolverine2 monitors in the control room to display the MIRC-X |
- | | + | |
* Digital 1 - VEGA | * Digital 1 - VEGA | ||
* Digital 2 - No Input | * Digital 2 - No Input | ||
- | * Display Port - MIRC-X \\ {{: | + | * Display Port - MIRC-X \\ {{: |
- | | + | - Make sure that the switch on the shelf above the montiors is set to the MIRC-X outputs. All outputs should be 1 or 2 for MIRC-X as shown in the following image: \\ {{: |
+ | - If either of the screens are split, then press the split screen button to the right of the screen change button on the front of the monitors so that a single display shows on each monitor. | ||
+ | - If one of the monitors is on the Display Port but is not showing the wolverine2 desktop, then you need to reset the display settings. From the pull down menu on the operational monitor, select " | ||
+ | - To get the mouse and keyboard to interact with the MIRC-X wolverine2 computer, make sure the two switches on top of the wolverine2 computer case are set to MIRC: \\ {{: | ||
+ | | ||