This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
chara:operating_procedures [2018/07/03 16:40] jones |
chara:operating_procedures [2018/07/03 16:47] jones |
||
---|---|---|---|
Line 2: | Line 2: | ||
__**OBSERVING PROCEDURES**__\\ | __**OBSERVING PROCEDURES**__\\ | ||
- | [[chara: | + | [[chara: |
+ | |||
+ | ====LAB PROTOCOL====\\ \\ {{/ | ||
+ | ====PREPARATIONS IN THE LAB PRIOR TO OBSERVING==== \\ \\ These are routine tasks to be performed in and around the lab every evening to prepare the array for regular observations.\\ \\ __2.1 Starting the vacuum pump for the light pipes__\\ Go into vacuum pump shack\\ | ||
* flip on power switch for pump (wait for blower to go on) | * flip on power switch for pump (wait for blower to go on) | ||
Line 88: | Line 91: | ||
* If using CLASSIC or CLIMB, turn on the black box above the NIRO computer, and then turn on the silver box below it on the same cart. | * If using CLASSIC or CLIMB, turn on the black box above the NIRO computer, and then turn on the silver box below it on the same cart. | ||
* After lab is completely setup, you need to take off tiptilt cover, but do so with only the dim lights on and the laser shutter closed >> you don't want to blast CCD with light. | * After lab is completely setup, you need to take off tiptilt cover, but do so with only the dim lights on and the laser shutter closed >> you don't want to blast CCD with light. | ||
- | \\ [[/ | + | \\ [[/ |
+ | |||
+ | ====SETTING UP COMPUTER IN THE CONTROL ROOM PRIOR TO OBSERVING==== \\ \\ __3.1 General Overview of Computer Setup__\\ | ||
* There are six computer screens which are now horizontally arrayed. | * There are six computer screens which are now horizontally arrayed. |