This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
chara:operating_procedures [2018/07/05 08:31] jones [Preparations in the Lab Prior to Observing] |
chara:operating_procedures [2018/07/05 08:32] jones [Setting up Computer in the Control Room] |
||
---|---|---|---|
Line 231: | Line 231: | ||
\\ | \\ | ||
+ | **Chapter 3: **(edited 2012Aug29 by Gail and Chris) | ||
====Setting up Computer in the Control Room==== | ====Setting up Computer in the Control Room==== | ||
- | \\ | ||
- | (edited 2012Aug29 by Gail and Chris)\\ | ||
\\ | \\ | ||
===3.1 General Overview of Computer Setup=== | ===3.1 General Overview of Computer Setup=== | ||
Line 252: | Line 251: | ||
\\ | \\ | ||
===3.2 After aligning the lab, you can turn on the following from the POWER GUI:=== | ===3.2 After aligning the lab, you can turn on the following from the POWER GUI:=== | ||
- | \\ | ||
\\ | \\ | ||
Line 263: | Line 261: | ||
\\ | \\ | ||
===3.3 Open servers required for observing=== | ===3.3 Open servers required for observing=== | ||
- | \\ | ||
\\ | \\ | ||
Line 294: | Line 291: | ||
===3.6 Using the Cosmic Debris job sequencer=== | ===3.6 Using the Cosmic Debris job sequencer=== | ||
\\ | \\ | ||
- | \\ | ||
Open Cosmic Debris, CD for short, - Primary from the menu and move to screen 4\\ | Open Cosmic Debris, CD for short, - Primary from the menu and move to screen 4\\ | ||
\\ | \\ | ||
Line 329: | Line 325: | ||
===3.7 Turn on metrology laser and home the carts=== | ===3.7 Turn on metrology laser and home the carts=== | ||
\\ | \\ | ||
- | \\ | ||
Turning on the metrology laser\\ | Turning on the metrology laser\\ | ||
Line 355: | Line 350: | ||
\\ | \\ | ||
===3.8 Synchronizing the clocks=== | ===3.8 Synchronizing the clocks=== | ||
- | \\ | ||
\\ | \\ | ||