chara:operating_procedures
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
chara:operating_procedures [2021/08/10 13:52] farringt0n |
chara:operating_procedures [2021/08/10 13:58] farringt0n |
||
|---|---|---|---|
| Line 154: | Line 154: | ||
| The gui that appears does much of the start up sequence remotely and does not fully start everything yet. This will eventually only require fewer steps to complete. | The gui that appears does much of the start up sequence remotely and does not fully start everything yet. This will eventually only require fewer steps to complete. | ||
| - | {{https:// | + | {{https:// |
| When the laser is on, the circle marked Laser will be green and the wattage listed will be close to 80mw (instead of 20mW when off) | When the laser is on, the circle marked Laser will be green and the wattage listed will be close to 80mw (instead of 20mW when off) | ||
chara/operating_procedures.txt ยท Last modified: 2023/09/01 02:50 by gail_stargazer
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
