This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
chara:operating_procedures [2021/08/10 13:52] farringt0n |
chara:operating_procedures [2021/10/13 16:56] farringt0n |
||
---|---|---|---|
Line 24: | Line 24: | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
- | {{: | + | {{: |
+ | {{: | ||
+ | {{: | ||
[[: | [[: | ||
Line 33: | Line 35: | ||
[[: | [[: | ||
[[: | [[: | ||
+ | [[: | ||
[[: | [[: | ||
- | [[: | + | [[: |
+ | |||
+ | [[: | ||
+ | |||
+ | \\ | ||
\\ | \\ | ||
__**DOCUMENTATION TO BE UPDATED**__ \\ | __**DOCUMENTATION TO BE UPDATED**__ \\ | ||
Line 40: | Line 47: | ||
\\ | \\ | ||
CHARA Array Operating Procedures\\ | CHARA Array Operating Procedures\\ | ||
- | Copyright © 2005-2020 The CHARA Team\\ | + | Copyright © 2005-2021 The CHARA Team\\ |
- | Last updated: | + | Last updated: |
\\ | \\ | ||
\\ | \\ | ||
Line 79: | Line 86: | ||
=== Preparations in the Lab Prior to Observing === | === Preparations in the Lab Prior to Observing === | ||
- | 27 AUG 2012 by Judit, Current version | + | 27 AUG 2012 by Judit, Current version |
These are routine tasks to be performed in and around the lab every evening to prepare the array for regular observations. Note that there is a new Daily Alignment Check Procedure for configurations that do not change night to night. Use it instead of the full alignment given here. | These are routine tasks to be performed in and around the lab every evening to prepare the array for regular observations. Note that there is a new Daily Alignment Check Procedure for configurations that do not change night to night. Use it instead of the full alignment given here. | ||
Line 139: | Line 146: | ||
If using CLASSIC or CLIMB, turn on the black box above the NIRO computer, and then turn on the silver box below it on the same cart. Remove cover on camera. After lab is completely setup, you need to take off tiptilt cover if using lab tiptilt, but do so with only the dim lights on and the laser shutter closed so as not to blast CCD with light. | If using CLASSIC or CLIMB, turn on the black box above the NIRO computer, and then turn on the silver box below it on the same cart. Remove cover on camera. After lab is completely setup, you need to take off tiptilt cover if using lab tiptilt, but do so with only the dim lights on and the laser shutter closed so as not to blast CCD with light. | ||
- | 2.6 Starting up OPLE and Metrology | + | 2.6 Starting up OPLE and Metrology |
\\ | \\ | ||
Line 344: | Line 351: | ||
If using Classic or CLIMB, check to make sure the dither is off by looking at the dither status in the CLASSIC/ | If using Classic or CLIMB, check to make sure the dither is off by looking at the dither status in the CLASSIC/ | ||
- | Shut down the ople control system: | + | Shut down the ople control system |
Close the OPLE server. | Close the OPLE server. |