This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
chara:operating_procedures [2023/02/13 20:37] charaobs |
chara:operating_procedures [2023/02/13 21:01] charaobs |
||
---|---|---|---|
Line 309: | Line 309: | ||
5.2 Opening telescope optics \\ \\ | 5.2 Opening telescope optics \\ \\ | ||
- | When the sun has set and before | + | About 20 minutes after the sun has set, it is dark enough to slew to your first target |
5.3 Check the OPLE carts \\ \\ | 5.3 Check the OPLE carts \\ \\ | ||
Line 398: | Line 398: | ||
Go inside the lab with booties: Turn off the silver box, then black box for NIRO and replace the NIRO camera cover if used. Turn off the key for the green alignment laser and turn the power switch off. Turn off Pico 3 controller above the tiptilt camera. Turn off the blue amplifiers for the metrology laser (button is labeled " | Go inside the lab with booties: Turn off the silver box, then black box for NIRO and replace the NIRO camera cover if used. Turn off the key for the green alignment laser and turn the power switch off. Turn off Pico 3 controller above the tiptilt camera. Turn off the blue amplifiers for the metrology laser (button is labeled " | ||
- | Check the 6 ople computers and RPC's for any components that were not turned off in the OPLESystem Control gui shutdown sequence. | + | Check the 6 ople computers and RPC's for any components that were not turned off in the OPLESystem Control gui shutdown sequence. Any + signs on the power controllers indicate power was left on. E1 computer is usually on. Push the Off button to turn off the component that is on. Scroll left and right using the UP/DOWN buttons to move to each + sign. Make sure all doors are closed as you leave. |
6.8 Odds and ends. \\ \\ | 6.8 Odds and ends. \\ \\ |