This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
chara:trouble_shooting [2021/11/04 18:04] charaobs [The Telescope won't move or stopped moving] |
chara:trouble_shooting [2021/11/04 18:06] charaobs [The Telescope won't move or stopped moving] |
||
---|---|---|---|
Line 86: | Line 86: | ||
**Azimuth Limit Switches** \\ | **Azimuth Limit Switches** \\ | ||
\\ | \\ | ||
- | As of 11-' | + | <font 14px/ |
\\ | \\ | ||
1. On the domegui MANUAL tab, click STOP so pulses won't be sent to the drive by the control software.\\ | 1. On the domegui MANUAL tab, click STOP so pulses won't be sent to the drive by the control software.\\ | ||
Line 96: | Line 96: | ||
4. Click ENABLE then you can move the telescope back to its normal range of operation.\\ | 4. Click ENABLE then you can move the telescope back to its normal range of operation.\\ | ||
\\ | \\ | ||
- | 5. After the telescope is back in it normal range, click OVERRIDE OFF which makes the hardware aware of the limits again. | + | 5. After the telescope is back in it normal range, click OVERRIDE OFF which makes the hardware aware of the limits again</ |
- | **< | + | < |
- | < | + | < |
\\ | \\ | ||
- | < | + | < |
\\ | \\ | ||
<font inherit/ | <font inherit/ | ||
- | < | + | < |
- | < | + | < |
- | < | + | < |
- | < | + | < |