chara:trouble_shooting
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
chara:trouble_shooting [2023/07/06 07:43] gail_stargazer |
chara:trouble_shooting [2023/07/06 07:45] gail_stargazer |
||
|---|---|---|---|
| Line 263: | Line 263: | ||
| Steps for adjusting MET2: | Steps for adjusting MET2: | ||
| - | - | + | - Looking at the met signal while the cart is at the back. |
| - | + | - Peak so that the beam is aligned as well as possible. Does not need to be perfect but not loose. | |
| - | Looking at the met signal while the cart is at the back. | + | - All beams have a signal between 1-2 volts while at the back. Sometimes the signal strength can change for no apparent reasons. |
| - | + | - Using steps of 50, try moving 3 times in one direction. After each step, wait 5 seconds or so for things to update. If nothing then try the other way. | |
| - | - | + | - Return to starting position. |
| - | + | - Repeat for the other axis. | |
| - | Peak so that the beam is aligned as well as possible. Does not need to be perfect but not loose. | + | |
| - | + | ||
| - | - | + | |
| - | + | ||
| - | All beams have a signal between 1-2 volts while at the back. Sometimes the signal strength can change for no apparent reasons. | + | |
| - | + | ||
| - | - | + | |
| - | + | ||
| - | Using steps of 50, try moving 3 times in one direction. After each step, wait 5 seconds or so for things to update. If nothing then try the other way. | + | |
| - | + | ||
| - | - | + | |
| - | + | ||
| - | Return to starting position. | + | |
| - | + | ||
| - | - | + | |
| - | + | ||
| - | Repeat for the other axis. | + | |
| ===== Beam Samplers ===== | ===== Beam Samplers ===== | ||
chara/trouble_shooting.txt · Last modified: 2024/06/18 00:21 by charaobs
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
