This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
chara:trouble_shooting [2023/07/06 07:50] gail_stargazer |
chara:trouble_shooting [2023/10/24 20:06] gail_stargazer |
||
---|---|---|---|
Line 195: | Line 195: | ||
S2's acquisition server resides on " | S2's acquisition server resides on " | ||
+ | |||
+ | ==== Focusing the Telescope ==== | ||
+ | |||
+ | - Fully align beacon to labao and TWFS, especially making sure the focus terms between the two agree very well. | ||
+ | - Open a secondary gui: mergurygtk W2_SECONDARY. | ||
+ | - Note the current M2 actuator positions and send them to Nic for the log. | ||
+ | - Turn off the beacons and lock the star on TWFS tiptilt. | ||
+ | - Turn the servo on in the mercurygtk gui. | ||
+ | - On the align tab of the wfsgtk there is a button for FOCUS SCOPE. | ||
+ | - Press the button. | ||
+ | - When done the focus term of starlight on the TWFS should be zero. | ||
+ | - Turn off the servo on the mercury_gtk gui. | ||
+ | |||
+ | A couple of notes: | ||
+ | |||
+ | * If large moves of M2 are made, tiptilt tracking may be lost. Pay careful attention so that M2 doesn' | ||
+ | * If it takes too long to start the autofocus procedure, the mercury_gtk servo will automatically turn off and nothing will happen. So just make sure the servo is on right before hitting the FOCUS SCOPE button. | ||
===== Dome issue ===== | ===== Dome issue ===== | ||
Line 229: | Line 246: | ||
==== LabAO Shutters Not Working ==== | ==== LabAO Shutters Not Working ==== | ||
- | If the labao shutters are not working, the power button on each of the two red control boxes on the top of the table might need to be pressed. After that the other button needs to be pressed and held for 5 seconds so that the units can be controlled remotely. (Note: look for instructions on table.) | + | <font 10.5pt font-family:/ |
+ | |||
+ | <font 10.5pt font-family:/ | ||
+ | |||
+ | <font 10.5pt font-family:/ | ||
==== LabAO DM Electronics ==== | ==== LabAO DM Electronics ==== | ||
Line 447: | Line 468: | ||
Follow instructions in the [[: | Follow instructions in the [[: | ||
+ | |||
+ | ==== No Power for Aperture Wheels ==== | ||
+ | |||
+ | To minimize heat sources in the lab, the power for the apwheels is turned off. If you need to use aperture wheels during the night, the operator will need to plug the power into the outlet next to the metrology table (see photo below). If there are any communication issues after plugging in the power, try restarting the server using bootlaunch on ctrscrut. It's probably a good idea to home the apwheels after turning on the power. | ||
+ | |||
+ | {{: | ||
\\ | \\ |