This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
chara:trouble_shooting [2023/07/27 20:10] gail_stargazer |
chara:trouble_shooting [2023/10/24 20:06] gail_stargazer |
||
---|---|---|---|
Line 246: | Line 246: | ||
==== LabAO Shutters Not Working ==== | ==== LabAO Shutters Not Working ==== | ||
- | If the labao shutters are not working, the power button on each of the two red control boxes on the top of the table might need to be pressed. After that the other button needs to be pressed and held for 5 seconds so that the units can be controlled remotely. (Note: look for instructions on table.) | + | <font 10.5pt font-family:/ |
+ | |||
+ | <font 10.5pt font-family:/ | ||
+ | |||
+ | <font 10.5pt font-family:/ | ||
==== LabAO DM Electronics ==== | ==== LabAO DM Electronics ==== | ||
Line 464: | Line 468: | ||
Follow instructions in the [[: | Follow instructions in the [[: | ||
+ | |||
+ | ==== No Power for Aperture Wheels ==== | ||
+ | |||
+ | To minimize heat sources in the lab, the power for the apwheels is turned off. If you need to use aperture wheels during the night, the operator will need to plug the power into the outlet next to the metrology table (see photo below). If there are any communication issues after plugging in the power, try restarting the server using bootlaunch on ctrscrut. It's probably a good idea to home the apwheels after turning on the power. | ||
+ | |||
+ | {{: | ||
\\ | \\ |