chara:coude_alignment_procedure
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
chara:coude_alignment_procedure [2021/06/02 18:59] gail_stargazer |
chara:coude_alignment_procedure [2021/06/02 19:05] gail_stargazer |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Written by Judit Sturmann on 2021 June 1. | Written by Judit Sturmann on 2021 June 1. | ||
| - | ==== Preparation | + | ==== Preparation ==== |
| * Make sure the vacuum is below 5 torr in the pipe. | * Make sure the vacuum is below 5 torr in the pipe. | ||
| Line 50: | Line 50: | ||
| * Go to the AOB ENG tab on the hut engineering gui and save the new default M7 position by hitting the “DICHROIC POSITION” (or similar) button, and then “SAVE ..(stg)”. [<this button is in the same row as the DICHROIC POSITION button.] A new configuration file is now saved, that also includes the tilts of beacon flat, AOB splitter, and focuses. | * Go to the AOB ENG tab on the hut engineering gui and save the new default M7 position by hitting the “DICHROIC POSITION” (or similar) button, and then “SAVE ..(stg)”. [<this button is in the same row as the DICHROIC POSITION button.] A new configuration file is now saved, that also includes the tilts of beacon flat, AOB splitter, and focuses. | ||
| - | ==== Revision History | + | ==== Revision History ==== |
| - | * Gail Schaefer added to wiki page on 6/2/2021. | + | * 2021Jun01 - Document written by Judit Sturmann. |
| + | * 2021Jun02 - Gail Schaefer added to wiki page. | ||
| + | * 2021Jun02 - Removed link for [[https://docs.google.com/ | ||
chara/coude_alignment_procedure.txt · Last modified: 2021/06/02 19:11 by gail_stargazer
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
