Differences

This shows you the differences between two versions of the page.

--- chara:labao_alignment_procedure [2023/09/27 14:58]
gail_stargazer
+++ chara:labao_alignment_procedure [2023/09/27 19:24] (current)
gail_stargazer
@@ Line 1: / Line 1: @@
 ====== LabAO Alignment Procedure ======
-This page is a work in progress. These procedures are based on notes from Theo 9/15/2023.
+This page is a work in progress. These procedures are based on notes from Theo on 9/15/2023.
 ===== Setting zero for the WFS =====
@@ Line 17: / Line 17: @@
 ===== Measuring a new Reconstructor =====
-The simple answer is to use the blue beacon after having carefully checked the alignment. This assumes that the focus, as determined by the lab WFS, is correct. This focus includes both the OPLE and the BRT alignments, but since we assume that anyway while observing it's probably OK. Other than that follow the same procedure Matt describes for the [[:chara:files:chara_telao_calibration_source_6.pdf|scope AO system]].
+The simple answer is to use the blue beacon after having carefully checked the alignment. This assumes that the focus, as determined by the lab WFS, is correct. This focus includes both the OPLE and the BRT alignments, but since we assume that anyway while observing it's probably OK. Other than that follow the same procedure Matt describes for the {{:chara:files:chara_telao_calibration_source_6.pdf|scope AO system}}.
 If you don't believe the BRT and/or OPLE are properly aligned (and they probably aren't) here is what I think should be done.

The CHARA Array Wiki