chara:power_recovery
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
chara:power_recovery [2022/07/19 20:04] gail_stargazer |
chara:power_recovery [2024/02/29 13:47] gail_stargazer |
||
|---|---|---|---|
| Line 17: | Line 17: | ||
| * All pops were out and PERI positions lost → All 6 PERI axes had to be homed and AFTER THAT set pop5 first with POPPERIGTK and adjusted M10 as needed. | * All pops were out and PERI positions lost → All 6 PERI axes had to be homed and AFTER THAT set pop5 first with POPPERIGTK and adjusted M10 as needed. | ||
| - | Additional Notes After Power Outage on August, 17, 2021 and June 2022. | + | Additional Notes After Power Outage on August, 17, 2021, June 2022, Feb 2024. |
| * Reinitialize the NIRO Filter Wheel. Open the niro_filter_gtk and click REINIT. Check to see if the indicator wheel on the NIRO camera is pointing to the correct filter after it is homed. Do not turn the wheel by hand. If it points to the wrong filter, home the filter wheel again, and compare counts for each filter (or look for metrology light in J-band) to confirm the correct filters are in position. Then loosen the screw on the indicator wheel and align so that it points to the correct filter label that is currently in. | * Reinitialize the NIRO Filter Wheel. Open the niro_filter_gtk and click REINIT. Check to see if the indicator wheel on the NIRO camera is pointing to the correct filter after it is homed. Do not turn the wheel by hand. If it points to the wrong filter, home the filter wheel again, and compare counts for each filter (or look for metrology light in J-band) to confirm the correct filters are in position. Then loosen the screw on the indicator wheel and align so that it points to the correct filter label that is currently in. | ||
| Line 34: | Line 34: | ||
| * load the new module: \\ sudo modprobe e1000e | * load the new module: \\ sudo modprobe e1000e | ||
| * ensure the module is persistent across a reboot: \\ sudo dpkg-reconfigure linux-image-$(uname -r) | * ensure the module is persistent across a reboot: \\ sudo dpkg-reconfigure linux-image-$(uname -r) | ||
| + | * | ||
| + | |||
| + | The STST chiller will power back on after an outage, but the cooler does not start automatically. Press the settings button to start the cooling again. | ||
chara/power_recovery.txt · Last modified: 2024/02/29 13:48 by gail_stargazer
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
