This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
chara:cophasing_with_the_new_chancam [2023/12/12 18:47] gail_stargazer created |
chara:cophasing_with_the_new_chancam [2023/12/12 18:54] (current) gail_stargazer |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Running the New ChanCam ====== | ====== Running the New ChanCam ====== | ||
- | For our fiber experiment, we put a new ZWO camera in place of the old ChanCam. | + | For our fiber experiment, we put a new ZWO camera in place of the old ChanCam. That requires some new software that is not described in the document about co-phasing on the wiki ({{: |
- | + | ||
- | That requires some new software that is not described in the document about co-phasing on the wiki. | + | |
**Step 1: **Plug in the power to the camera (see the attached photo). | **Step 1: **Plug in the power to the camera (see the attached photo). | ||
- | We usually leave it off because it produces heat and blows air. | + | |
+ | * To turn it on, plug in the black power cable and make sure the LED is on. | ||
+ | * Hold the camera while you do this, it can rotate easily. | ||
- | To turn it on, plug in the black power cable and make sure the LED is on. | + | **Step 2:** Run the server. |
- | Hold the camera while you do this, it can rotate easily. | + | |
- | + | | |
- | **Step 2: **Run the server. | + | |
- | + | ||
- | Log into the tiptilt computer as user observe (ssh -XY observe@tiptilt), | + | |
- | + | ||
- | zwo_server_ASI294 -O CHAN | + | |
**Step 3: **Run the GUI. | **Step 3: **Run the GUI. | ||
- | Log into the tiptilt computer again and type: | + | * Log into the tiptilt computer again and type: |
- | + | | |
- | zwogtk_ASI294 CHAN | + | |
- | + | ||
- | The new ASI294 camera produces pretty big images that can overload the messaging system. | + | |
- | This means that the connection between client and server will break annoyingly often. | + | The new ASI294 camera produces pretty big images that can overload the messaging system. |
- | If the GUI stops showing new images, hit REOPEN and START CAM again. | + | {{: |