User Tools

Site Tools


chara:archived_procedures

This is an old revision of the document!


Archived Procedures

For those who are nostalgic for the olden days, we are backing up primitive and outdated procedures.

New S2 Finder Instructions command line instructions for the first finder camera installation.

Tiptilt Server:

Instructions for old lab tiptilt server (these sections apply to the old lab tiptilt system retired in April 2021).

From the Observing Procedures page:

(This section is obsolete with the retiring of the old lab tiptilt)
Establish connection between tiptilt and the telescopes. On the Control Tab on Cosmic Debris, click on [TIPTILT COMM]. Click [START JOB QUEUE] on CD to continue the Tiptilt Communication sequence. After several seconds, the telescope servers will indicate that the Socket (SOC) connection is established and turn on the tiptilt rate display. Cosmic Debris will usually display a lower rate, such as 42Hz, to indicate tiptilt is running. The servers will display 158Hz to show a proper functioning of the tiptilt system. If the connection is not established the first time, try again until CD shows rates for each telescope used. If a telescope server will not display a TT signal rate, you may need to shut it down and restart it. Once the telescope WFS's are used for tiptilt, these steps for the lab tiptilt will not be used.
Finish setting up tiptilt GUIs. Click re-open on the Tiptilt GUI. This will update the TT labels on the TT viewing screens from B1,B2,etc to the telescope names. Click on the [SERVO CONTROL] tab on the tiptilt GUIto bring up a second window and move to screen 5 with the telescope guis. The Servo Control GUIallows you to turn ON the servo for the TT loop and make biases for individual beams (DBIAS and ZBIAS)

FLUOR:

Nic can add instructions here, but it probably consists of opening the JuFlu server and GUI. There was a time when we had to open up a special Cosmic Debris for FLUOR by typing the following command into a terminal window:

cosmic_fluor -F -o2 (for a secondary program using secondary ople)

chara/archived_procedures.1641852797.txt.gz · Last modified: 2022/01/10 17:13 by charaobs